2007 Arctic Cat ATVs factory service and repair manual, Page 145Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 145

4Install the movable face sleeve aligning the hole in the spring seat with the spring anchor hole in the movable face 5Install
holder on the spring engaging the spring end with the appropriate anchor hole 9Continue corn ressing the ring while guiding
the spring ho der onto the ubWhen slight resistance is felt, stop turning the wing nut 10Install the nut (threads coated
with red Loctite #271); then tighten the nut to specification using the spanner and torque wrench 11Remove the wing nut,
washer, and holding handle; then remove the driven pulley from the pulley compressor Page: 145 Arctic Cat ATV 2007 -All Models