2007 Arctic Cat ATVs factory service and repair manual, Page 146Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 146

Servicing Center Crankcase Components Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
start with the original shims on the rear shaft 1Place the left-side crankcase cover onto the left-side crankcase half to
prevent runout of the secondary transmission output shaft2Install the secondary driven output shaft assembly onto the crankcase
4Install the secondary driven output shaft assembly5Rotate the secondary driven bevel gear several revolutions in both directions
3Mount the indicator tip of the dial indicator on the secondary driven bevel gear 6Examine the tooth contact pattern in the
dye and compare the pattern to the illustrationsIncorrect (contact at tooth top) 4While rocking the driven bevel gear back
and forth, note the maximum backlash reading on the gauge5Acceptable backlash range is 0.05-0.33 mm (0.002-0.013 inCorrecting
Backlash 1 NOTE: If backlash measurement is within the acceptable range, no correction is necessary 1If backlash measurement