2007 Arctic Cat ATVs factory service and repair manual, Page 147Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 147

Correct Correcting Tooth Contact 1 NOTE: If tooth contact pattern is comparable to the correct pattern illustration, no correction
Thickness i NOTE: To correct tooth contact, steps and 2 (with NOTE) of "Correcting Backlash" must be followed and the above
"Tooth ContactIShim Correction" chart must be consulted 3Maximum deflection must not exceed specificationsMeasuring Connecting
Rod (Big End Side-to-Side) A CAUTION After correcting tooth contact, backlash must again be checked and corrected (if necessary)Continue
the correcting backlashlcorrecting tooth contact pro- 1Push the lower end of the connecting rod to one side of the crankshaft
journal 2Using feeler gauge, measure the gap between the connecting rod and crankshaft journal CRANKSHAFT ASSEMBLY Measuring
Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into the upper connecting rod smal1 end bore; then remove the