2007 Arctic Cat ATVs factory service and repair manual, Page 148Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 148

Measuring Connecting Rod (Big End Width) 1Using call ers, measure the width of the connecting ro rat the big-end bearing
securing the reverse driven gear2Remove the reverse driven gear and account for the washer, bushing, and bearing3Remove the
low driven gear washer; then remove the low driven gearAccount for the bushing and bearing Care should be taken to support
the connecting rod when rotatina the crankshaft 4Maximum runout must not exceed specifications1 NOTE: Proceed to check runout
on the other end of the crankshaft by positioning the indicator contact at point and following steps 2-4 4Remove the washer;
then remove the circlip securing the sliding dogRemove the sliding dog5Remove the high driven gear circlip; then remove the
high driven gearAccount for the washer, bushing, and bearing Measuring Crankshaft (Web-to-Web) 1Using calipers, measure the
distance from the outside edge of one web to the outside edge of the other web Page: 148 Arctic Cat ATV 2007 -All Models