2007 Arctic Cat ATVs factory service and repair manual, Page 149Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 149

Assembling Disassembling 1Remove the small and large washers from the balancer shaft2Note the position of the alignment marks
the alignment marks of driven gear #1 and driven gear #22Using pair of needle-nose pliers, insert each spring part way into
the slot; then install pin and push the springlpin assembly into the slot 3Place the key and the large washer into position
on the balancer shaft4Place the driven gear #1 assembly onto the balancer shaft; then place the large and small washers onto
the shaft1NOTE: The crank balancerldriven gear assembly is now completely assembled for installation 4Place the reverse driven
gear onto the countershaft making sure the bearing, bushing, and washer are properly positioned; then secure with the circlip
5Place the reverse driven gear dog onto the countershaft; then secure with the circlip1NOTE: The countershaft is now completely
assembled for installation Assembling Crankcase Half 1NOTE: For ease of assembly, install components on the right-side crankcase