2007 Arctic Cat ATVs factory service and repair manual, Page 152Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 152

1Install the secondary and primary driveshaft assembliesAccount for the bearing alignment C-ring on the bearing boss next
left-side half 5In crisscrosscase-to-case pattern, tighten the mm cap screws until the halves are correctly joined; then
tighten to specifications1NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 6In crisscrosscase-to-case
pattern, tighten the mm cap screws to specifications1NOTE: Rotate the shafts back and forth to ensure no binding or sticking
occurs a plastic lightly tap the case B AT THIS POINT cap screws; then tighten only until snugI NOTE: Rotate the shafts back