2007 Arctic Cat ATVs factory service and repair manual, Page 153Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 153

Installing Right-Side Components AOil Strainerfoil Pump 1Place the oil strainer and new O-ring into position beneath the
oil pump driven gear 2Noting the directional arrow from removing, place the strainer cover into position on the crankcase
making sure the O-ring is properly installed and secure with the four cap screws; then tighten the oil drain plug to specifications
5Install the cam chain3Place two alignment pins and the oil pump into position on the crankcase and secure with the Phillips-head
screws coated with blue Loctite #243Tighten to specifications1 NOTE: Keep tension on the cam chain to avoid damaging the