2007 Arctic Cat ATVs factory service and repair manual, Page 154Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 154

10Install gear position indicator switch making sure the O-ring is well-oiled and properly positionedTighten cap screws securely
nut; it has "left-hand" threads BClutch Cover CFixed Drive Face DMovable Drive Face i NOTE: Steps 1-10 in the preceding sub-section
must precede this procedure 8Install the one-way sprag clutch making sure that the green dot or the stamp tag OUTSIDE is
directed away from the crankcase 11Install two alignment pins and place the clutch cover gasket into positionInstall the