2007 Arctic Cat ATVs factory service and repair manual, Page 156Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 156

Making sure the eight movable drive face rollers are in position, pinch the V-belt together near its center and slide the
screws securely 2Install the starter motor and tighten the two cap screws securely3Install the driveshaft spacer making sure
the stepped side is to the inside1 NOTE: At this point, the wedge can be removed from between the driven pulley faces 19Rotate
the V-belt and driveldriven assemblies until the V-belt is flush with the top of the driven pulley20Install two alignment
pins and place the V-belt cover gasket into position on the clutch coverInstall the V-belt cover noting the position of the