2007 Arctic Cat ATVs factory service and repair manual, Page 158Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 158

12Place the gasket, recoil starter assembly, and cover into position on the left-side cover making sure the single washer
the open end of the circlip isdirected upwards or downwards 1 NOTE: The piston should be installed so the arrow points towards
the exhaust # Compression 1 Oil Ring Expander End Gap 1NOTE: Note the direction of the exhaust side of the piston (5) for
correct ring end gap orientation BInstall the compression rings (1 and 2) so the letter on the top surface of each ring faces
the dome of the pistonRotate the rings until the ring end gaps are on directly opposite sides of the piston according to
the illustration1NOTE: The chrome (silver) ring should be installed in the top position 2Place the two alignment pins into
positionPlace the cylinder gasket into position; then place piston holder (or suitable substitute) beneath the piston skirt