2007 Arctic Cat ATVs factory service and repair manual, Page 175Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 175

B AT THIS POINT To service center crankcase components only, proceed to Removing Left-Side Components Left-Side Components
CCover DRotorIFlywheel 1 NOTE: The 500 and certain 650 H1 models are equipped with recoil starter A CAUTION Do not allow
the connecting rod to go down inside the crankcaseIf the rod is down inside the crankcase and the crankshaft is rotated,
severe damage will result If the existing rings will not be replaced with new rings, note the location of each ring for proper
installationWhen replacing with new rings, replace as complete set onlyIf the piston rings must be removed, remove them in
this sequence 1Remove the four cap screws securing the recoil starterlouter magneto cover to the left-side cover; then remove
the recoil starterlouter magneto coverAccount for the gasket AStarting with the top ring, slide one end of the ring out of
the ring-groove B AT THIS POINT To service the recoil starter, see Servicing Left-Side Components sub-section BRemove each
ring by working it toward the dome of the piston while rotating it out of the groove B AT THIS POINT To service piston, see