2007 Arctic Cat ATVs factory service and repair manual, Page 177Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 177

i 12Remove the snap ring securing the water pump drive sear: then remove the sear notins the direction of the sides of the
of the sear for installins purposesAccount for the driven gear alignment pin 11Remove the two starter gears from the crankcase
noting the direction of the beveled side of the gears for installing purposes; then remove the two starter gear shafts 1
NOTE: There is an oil passage beneath the driven gearldrive gear assemblyThis passage should be plugged prior to removing