2007 Arctic Cat ATVs factory service and repair manual, Page 183Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 183

6Using rubber mallet, tap on the crankcase to remove the driveshaft Remove the shift shaft (H); then remove the two forks
(B) gear and crankshaft (C) gear for assembling purposes; then slide the crank balancer gear off the crank balancerAccount
for the key in the keyway Remove the countershaft assembly) Account Dfor washer on each end of the countershaft8Remove the
crank balancer1NOTE: There is flat spot on the crank balancer bearing flange to allow clearance past the crankshaft Page: