2007 Arctic Cat ATVs factory service and repair manual, Page 186Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 186

ATV-I 082 2Maximum runout must not exceed specificationsMeasuring Valve Stem Outside Diameter 3Rotate the valve in the blocks
the dial indicator contact point against the outside edge of the valve faceZero the indicator 1Using micrometer, measure
the width of the 3Push the valve from side to side; then from top to bottom 2Acceptable width range must be within specificationsMeasuring
Valve Face Radial Runout 4Maximum ''wobble" deflection must not exceed specificationsMeasuring Valve Guide (Inside Diameter)
1Mount dial indicator on the surface plate; then place the valve stem on set of blocks2Position the dial indicator contact
point on the outside edge of the valve face; then zero the indicator 1Insert snap gauge 112 way down into each valve guide