2007 Arctic Cat ATVs factory service and repair manual, Page 190Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 190

3Place the cylinder head on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder
A CAUTION Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry sandpaper or damage to the sealing
surface may resultMeasuring Cylinder Head Distortion A CAUTION Water or parts-cleaning solvent must be used in conjunction
with the wet-or-dry sandpaper or damaqe to the sealinq surface may result 1Remove any carbon buildup in the combustion chamber2Lay
straightedge across the cylinder head; then using feeler gauge, check the distortion factor between the head and the straightedge
Inspecting Cam Chain Guide 1Inspect cam chain guide for cuts, tears, breaks, or chips2If the chain guide is damaged7 it must
be replacedHoning Cylinder 3Maximum distortion must not exceed specifications 1Using slide gauge and dial indicator or snap
gauge, measure the cylinder bore diameter in three locations from top to bottom and again from top to bottom at 90' from