2007 Arctic Cat ATVs factory service and repair manual, Page 194Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 194

9Remove the spring from the case by lifting the spring end up and outHold the remainder of the spring with thumbs and alternately
1If removed, insert the spiral spring into the case with the outer end of the spring around the mounting lug in the case;
then wind it in counterclockwise direction until the complete spring is installed1NOTE: The spiral spring must seat evenly
in the recoil case Care must be taken when lifting the reel free of the caseWear safety glasses to avoid injuryB606D 8Remove
the protective cover from the starter handle and pull the rope out of the handle; then untie the knot in the rope and remove
the handle 1NOTE: Do not remove the spiral spring unless replacement is necessaryIt should be visually inspected in place
to save timeIf replacement is necessary, follow steps 9-10 2Insert the rope through the hole in the reel and tie knot in
the end; then wrap the rope counterclockwise around the reel leaving approximately 50 cm (20 in of rope free of the reel