2007 Arctic Cat ATVs factory service and repair manual, Page 195Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 195

Apply low-temperature grease to the spring and hubThread the end of the rope through the guide hole of the case; then thread
in the notch of the reel11Rotate the reel four turns counterclockwise; then release the rope from the notch and allow the
rope to retract 12Pull the rope out two or three times to check for correct tension NOTE: Increasing the rotations in step
11 will increase spring tension 7Install the friction spring and the spring cover 13Place the recoil starter assembly into