2007 Arctic Cat ATVs factory service and repair manual, Page 196Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 196

INSPECTING OIL PUMP Servicing Right-Side Components IWhenever part is worn excessively, cracked, damaged in any way, or out
spring assemblyDO NOT attempt disassembling without the proper tools 1Secure Driven Pulley Compressor (pln 0444- 121) in
suitable holding fixture such as bench vise; then remove the wing nut, holding handle, flat washer, and pilot bushing leaving
the large spacer on the compressor tool baseInspecting clutch shoe groove ATV1014 INSPECTING CLUTCH HOUSING 1Inspect the
clutch housing for burns, grooving7 cracksor uneven wear2If the housing is damaged in any way, the housing must be replacedINSPECTING
PRIMARY ONE-WAY DRIVE 1Insert the drive into the clutch housing2Rotate the inner race by hand and verify the inner race rotates
only one direction 2Place the driven pulley assembly onto the compressor tool base engaging the dowel pins into appropriate