2007 Arctic Cat ATVs factory service and repair manual, Page 197Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 197

3Install the pilot bushing with the machined end directed down; then fitthe bushing into the pulley hubspring assembly is
to relax the spring1NOTE: There will be tendency for the handle to rotate clockwise approximately turn as the spring holder
clears the flats or hubThis is due to slight counterclockwise preload on the spring 5Place the holding handle on the spring
holder fitting the two dowel pins into the spring holder face; then install flat washer and the wing nutTurn the wing nut
down until resistance is felt1NOTE: Do not use the wing nut to compress the spring further Page: 197 Arctic Cat ATV 2007