2007 Arctic Cat ATVs factory service and repair manual, Page 199Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 199

1NOTE: Make sure the spacer is on the base or damage to the fixed face will occur when the spring is compressed 5Install
spring end with the appropriate anchor hole 3Install the four pins and spacers into the fixed face hub; then pack the cam
slots in the movable face with multi-purpose grease 7Assemble the notched-ring nut, spring holding handle, one flat washer,
and the wing nut in order on the pulley compressor bolt; then thread the wing nut onto the bolt 4Install the movable face
sleeve aligning the hole in the spring seat with the spring anchor hole in the movable face Page: 199 Arctic Cat ATV 2007