2007 Arctic Cat ATVs factory service and repair manual, Page 200Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 200

Servicing Center Crankcase Components 1 NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
so the tip is contacting tooth on the secondary driven bevel gearCD052A 9Continue compressing the spring while guiding the
spring holder onto the hubWhen slight resistance is felt, stop turning the wing nut 4While rocking the driven bevel gear
back and forth, note the maximum backlash reading on the gauge5Acceptable backlash range is 0.05-0.33 mm (0.002-0.013 inCorrecting
Backlash 1 NOTE: If backlash measurement is within the acceptable range, no correction is necessary 10Install the nut (threads
coated with red Loctite #271); then tighten the nut to specification using the spanner and torque wrench 1If backlash measurement
is less than specified, remove an existing shim, measure it, and install new thinner shim2If backlash measurement is more
than specified, remove an existing shim, measure it, and install thicker shim 1 NOTE: Continue to remove, measure, and install