2007 Arctic Cat ATVs factory service and repair manual, Page 201Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 201

Backlash Measurement Shim Correction Decrease Shim Thickness No Correction Required Increase Shim Thickness Under 0.05 mm
Contact Shim Correction 5Rotate the secondary driven bevel gear several revolutions in both directions 1 Contacts at Top
1 Contacts at Root 1Thickness Shim lncrease Shim Thickness 6Examine the tooth contact uattern in the dve and compare the
pattern to the illustrationsIncorrect (contact at tooth top) 1 NOTE: To correct tooth contact, steps and (with NOTE) of "Correcting
Backlash" must be followed and the above "Tooth ContactIShim Correction" chart must be consulted A CAUTION After correcting
tooth contact, backlash must again be checked and corrected (if necessary)Continue the correcting backlashlcorrecting tooth
contact pro- CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) Incorrect (contact at tooth root) 1Insert
snap gauge into the upper connecting rod small end bore; then remove the gauge and measure it with micrometer Page: 201 Arctic