2007 Arctic Cat ATVs factory service and repair manual, Page 203Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 203

COUNTERSHAFT Assembling A CAUTION From the left side: 1Install the sliding dog (14), driven gear washer (13), and bushing
Gear Spacer Washer Reverse Driven Gear Bearing Bushing 10Lock Washer 11Lock Washer 23456789 121314151617 Low Driven Gear
Driven Gear Washer Sliding Dog High Driven Gear Drive Gear Washer (L) Drive Gear Washer (R) 739-954 1 NOTE: When installing
the countershaft assembly, account for the washer on each end of the shaft Assembling Crankcase Half 1Install the output
shaft assembly into the crankcase making sure the two gears, shim, washer, and nut are properly sequenced Disassembling From
the right side: 1Remove the right drive gear washer (17); then remove drive gear #2 (2)2Remove the reverse driven gear dog
(3); then remove the circlip (4) 3Remove the reverse driven gear spacer (5); then remove the circlip (4)4In order, remove
washer (6), reverse driven gear (7), bearing (8), and bushing (9)5In order, remove washer (6), lock washer (10, lock washer
(11), and low driven gear (12)6In order, remove bearing (8), bushing (9), and driven gear washer (13)From the left side: