2007 Arctic Cat ATVs factory service and repair manual, Page 205Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 205

11Install the front and rear secondary driven shaft assemblies into the left side of the crankcase making sure the bearing
oil strainer into position; then secure with the two screws 13Place the oil strainer cap into position making sure the O-ring
is in position; then secure the cap with cap screwsTighten securely Joining Crankcase Halves 1Apply High-Temp Sealant to
the left-side mating surface2Lightly oil all bearings and grease all shafts in the right-side crankcase10Install the reverse
idler gear assembly noting the positioning of the two washers, gear, bushing, and shaft3Using propane torch, heat the right-side
crankshaft bearing until the oil begins to smoke; then join the two crankcase halves Using plastic mallet, lightly tap the