2007 Arctic Cat ATVs factory service and repair manual, Page 206Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 206

l NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 6From the left side, install the remaining
NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 10In crisscrosscase-to-case pattern, tighten
the rnm cap screws (from steps 7-8) to specificationsl NOTE: Rotate the shafts back and forth to ensure no binding or sticking
occurs 2Install the secondary shaft bearing housing making sure the two alignment pins are properly positionedTighten the
Allen-head screws securely B AT THIS POINT After completing center crankcase components, proceed to Installing Right-Side
Components, to Installing Left-Side Components, and to Installing Top-Side Components Installing Right-Side Components 1Install
the shift indicator sending unit making sure the two neutral contact pins and the two springs are properly positionedTighten