2007 Arctic Cat ATVs factory service and repair manual, Page 207Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 207

Install the oil pump drive gear spacer onto the crank balancer shaftGrease the pin and insert it into the shaft; then install
(with the flat side facing the assembly as noted in removing) and the nut (threads coated with red Loctite #271)Tighten to
specificationsCD991 Care must be taken that the directional washer be installed correctly and note that the nut has left-hand
threads 5Grease the driven gear pin and insert it into the oil pump shaft; then install the driven gear (noting the direction