2007 Arctic Cat ATVs factory service and repair manual, Page 209Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 209

15Spread the faces of the driven pulley by pushing the inner face toward the engine while turning it counterclockwise; then
Plug the oil passage in the crankcase housing prior to installing the drive gearldriven gear assembly to prevent loss of
an alignment pin 17Pinch the V-belt together near its center and slide the spacer and movable drive face onto the shaftSecure
the drive face with nut (threads coated with red Loctite #271)Tighten the nut to specifications Make sure the splines extend
beyond the drive face or false torque reading and spline damage may occur 1Install the water pump driven gear alignment pin
and the driven gear (with the beveled side of the gear facing outward as noted in removing); then secure with the snap ring