2007 Arctic Cat ATVs factory service and repair manual, Page 212Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 212

14Install the crossover tube on the water pump and cylinder head making sure the O-ring is properly positioned15Install the
the cap screws (from step 9) to specifications12Place the speed sensor housing and gasket into position and secure with the
two cap screwsTighten securely 1 NOTE: If the piston rings were removed, install them in this sequence AInstall ring expander
(4) in the bottom groove of the piston; then install the thin oil rings (3) over the expander making sure the expander ends
do not overlapStagger the end gaps of the upper and lower thin oil rings according to the illustration# Compression I Ring
End Gap Compression Ring End Gap 13Place the water pump into position and secure with two cap screwsTighten securely Oil
Ring Expander End Gap ATV-10851 1 NOTE: Note the direction of the exhaust side of the piston (5) for correct ring end gap