2007 Arctic Cat ATVs factory service and repair manual, Page 215Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 215

9Loosely install the five cylinder head nuts10In crisscross pattern, tighten the four cylinder head cap screws (from step
the timing inspection plug removed and the chain held tight, rotate the crankshaft until the piston is at top-dead-center12With
the alignment pin installed in the camshaft, loosely place the cam sprocket (with the recessed side facing the cam shaft
lobes) onto the camshaftAt this point, do not "seat" thsprocket onto the shaft 15Seat the cam sprocket onto the camshaft
making sure the alignment pin in the camshaft aligns with the smallest hole in the sprocket; then place the camshaftlsprocket
assembly onto the cylinder ensuring the following 1NOTE: At this point, oil the camshaft bearings, cam lobes, and the three
seating journals on the cylinder 13While holding the cam chain sprocket to the side, install the rear cam chain tensioner
guide into the cylinder headInstall the pivot cap screw and washer APiston still at top-dead-center3-178 Page: 215 Arctic