2007 Arctic Cat ATVs factory service and repair manual, Page 226Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 226

1 NOTE: Keep the mounting hardware with the covers for assembly purposes or thread them back into the head to keep them separated
To service any one specific component, only limited disassembly of components may be necessaryNote the AT THIS POINT information
in each sub-section i NOTE: The engineltransmission does not have to removed from the frame for this procedure Removing Top-Side
Components AValve Cover BCylinder Head 1 NOTE: Remove the spark plug and timing inspection plug; then using the recoil starter,
rotate the crankshaft to top-dead-center of the compression stroke 1Remove the two tappet covers 1 NOTE: Note that the opening
of the head plug must be directed to the o'clock position 3Loosen the cap screw on the end of the tensioner; then remove