2007 Arctic Cat ATVs factory service and repair manual, Page 227Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 227

5Bend the washer tabs and remove the two cap screws securing the sprocket to the camshaft; then drop the sprocket off the
for washer); then remove the tensionerCC011D 4Using an awl, rotate the C-ring in its groove until it is out of the cylinder
head; then remove the C-ringCare should be taken not to drop the C-ring down into the crankcase1NOTE: 7Remove the five nuts
securing the cylinder head to the cylinder; then remove the four cylinder head cap screws with copper washers (note location