2007 Arctic Cat ATVs factory service and repair manual, Page 242Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 242

ES- AT THIS POINT To service gear shift forks, see Servicing Center Crankcase Components sub-section 6Remove the reverse
should use discretion and sound judgment 8Remove the front output shaft (J) and rear shaft assembliesAccount for the bearing
C-ring1 NOTE: Note the alignment marks on the crank balancer driven gear and balancer drive gear to aid in assembly1 NOTE:
There is flat spot on the crank balancer to allow clearance past the crankshaft 11Using the Crankcase Separatorlcrankshaft
Remover (pln 0444-009), push the crankshaft assembly out of the crankcase 9Remove the driven gear from the crank balancer
assembly (A)Account for key ES- AT THIS POINT T service crankshaft assembly, see Servicing Ceno ter Crankcase Components