2007 Arctic Cat ATVs factory service and repair manual, Page 243Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 243

12To remove the output shaft and searremove the nut, slide the gear off the shaft (account for shim or shims), and drive
on the Surface Plate (pln 0644-016) covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the valve cover
in figure eight motionInspect the sealing surface for any indication of high spotsA high spot can be noted by bright metallic
finishCorrect any high spots before assembly by continuing to move the valve cover in figure eight motion until uniform bright
metallic finish is attained Servicing Top-Side Components 3-206 Valve Assembly 3-206 Piston Assembly 3-209 CylinderICylinder
Head Assembl Servicing Left-Side Components Recoil Starter 3-214 Measuring Shift Fork (Thickness) 3-217 Measuring Shift Fork
Groove (Width) 3-218 Measuring Shift Fork To Groove (Side Clearance) 3-218 Servicing Right-Side Components 3-218 Primary
Clutch Assembly 3-218 Inspecting Oil Pump 3-221 Servicing Center Crankcase Components 3-221 Secondary Gears 3-221 A CAUTION