2007 Arctic Cat ATVs factory service and repair manual, Page 249Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 249

Cleaningllnspecting Cylinder 1Wash the cylinder in parts-cleaning solvent2Inspect the cylinder for pitting, scoring, scuffing,
oilThoroughly clean cylinder after honing using soap and hot waterDry with compressed air; then immediately apply oil to
the cylinder boreIf the bore is severely damaged or gouged, replace the cylinder A CAUTION Water or parts-cleaning solvent
must be used in conjunction with the wet-or-dry sandpaper or damage to the sealing surface may result Inspecting Cam Chain
Guide 1Inspect cam chain guide for cuts, tears, breaks, or chips2If the chain guide is damaged, it must be replacedHoning
Cylinder 4If any measurement exceeds specifications, replace the cylinderMeasuring Camshaft Runout 1 NOTE: If the camshaft
is out of tolerance, it must be replaced 1Using slide gauge and dial indicator or snap gauge, measure the cylinder bore diameter
in three locations from top to bottom and again from top to bottom at 90' from the first measurements for total of six measurementsThe