2007 Arctic Cat ATVs factory service and repair manual, Page 253Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 253

Assemblingllnstalling 1If removed, insert the spiral spring into the case with the outer end of the spring around the mounting
counterclockwise around the reel leaving approximately 50 cm (20 in of rope free of the reel3Apply low-temperature grease
to the spring and hub 10Unwind the rope from the reel and remove the ropeCleaning and Inspecting 1Whenever part is worn excessively,
cracked, or damaged in any way, replacement is necessary 4Thread the end of the rope through the guide hole of the case;
then thread the rope through the handle and secure it with double knotInstall the protective cover into the handle5Align
the inner hook of the spiral spring with the notch in the reel 1Clean all components2Inspect the springs and ratchet for
wear or damage 3Inspect the reel and case for cracks or damage4Inspect the shaft for wear, cracks, or damage5Inspect the
rope for breaks or fraying6Inspect the spiral spring for cracks, crystallization, or abnormal bends6Install the ratchet onto