2007 Arctic Cat ATVs factory service and repair manual, Page 258Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 258

Servicing Center Crankcase Components H NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
half to prevent runout of the secondary transmission output shaftInstall the secondary driven output shaft assembly onto
the crankcaseMount the indicator tip of the dial indicator on the secondary driven bevel gearWhile rocking the driven bevel
gear back and forth, note the maximum backlash reading on the gaugeAcceptable backlash range is 0.05-0.33 mm (0.002-0.013
inCorrecting Backlash H NOTE: If backlash measurement is within the acceptable range, no correction is necessary 1Inspect
the pump for damage2It is inadvisable to remove the screw securing the pump halvesIf the oil pump is damaged, it must be
replaced 1If backlash measurement is less than specified, remove an existing shim, measure it, and instal1 new thinner shim
2If backlash measurement is more than specified, remove an existing shim, measure it, and install thicker shimW NOTE: Continue