2007 Arctic Cat ATVs factory service and repair manual, Page 260Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 260

Measuring Connecting Rod (Big End Width) 1Using cali ers, measure the width of the connecting ro rat the big-end bearing
deflection must not exceed specificationsMeasuring Connecting Rod (Big End Side-to-Side) 3Zero the indicator and rotate the
crankshaft slowly 1Push the lower end of the connecting rod to one side of the crankshaft journal2Using feeler gauge, measure
the gap between the connecting rod and crankshaft journal A CAUTION Care should be taken to support the connecting rod when
rotating the crankshaft 4Maximum runout must not exceed specifications1 NOTE: Proceed to check runout on the other end of
the crankshaft by positioning the indicator contact at point and following steps 2-4 Measuring Crankshaft (Web-to-Web) 1Using
calipers, measure the distance from the outside edge of one web to the outside edge of the other webCC289D 3Acceptable gap