2007 Arctic Cat ATVs factory service and repair manual, Page 272Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 272

crankcase halves, turn the shift cam to ensure all gears shift properly 1 NOTE: Prior to joining 4From the right side, install
snug 1 NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 2Using plastic mallet, lightly tap
the case halves together until cap screws can be installed3From the left side, install the three case half mm cap screws
(two inside the case); then tighten only until snug1 NOTE: Rotate the shafts back and forth to ensure no binding or sticking
occurs 6From the right side, install the five case half mm cap screws (one inside the case); then tighten only until snugl