2007 Arctic Cat ATVs factory service and repair manual, Page 273Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 273

2Place the strainer cap into position on the strainer making sure new O-ring is properly installed and secure with the cap
to specifications A CAUTION After completing center crankcase components, proceed to Installing Right-Side Components, to
Installing Left-Side Components, and to In- stalling Top-Side Components Installing Right-Side Components Oil Strainerfoil
Pump Gear Shift Shaft 4Place the pin and washer into position on the oil pump shaft, install the oil pump driven gear, and
secure with the circlip Place the oil strainer into position beneath the crankcase and tighten securely with the Phillips-head
cap screws 5Place the gear shift cam plate and guide onto the gear shift cam making sure the alignment pin was installedSecure