2007 Arctic Cat ATVs factory service and repair manual, Page 275Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 275

12Using the Clutch Sleeve Hub Holder (pln 0444-007), install the nut and washerTighten to specifications 10Install the primary
the sleeve is properly positioned in the primary assembly 14Install the clutch shoe and washer; then secure with the starter
clutch shoe nut (left-hand threads)Tighten to specifications; then using center punch, stake the nut15Install the release
roller assembly making sure the four springs are in position; then using crisscross pattern, tighten the four cap screws
securely1NOTE: Tighten the four roller assembly cap screws in crisscross pattern making sure there is no clearance between
the clutch plates when secured 1NOTE: Note the alignment mark scribed on the primary driven gear assembly during disassembly