2007 Arctic Cat ATVs factory service and repair manual, Page 276Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 276

6Install the clutch release arm and release roller guide making sure the release roller and guide are aligned FWater Pump
#243Tighten securely 1 NOTE: Care should be taken that the alignment pins are installed in the right-side cover 18Install
the reverse cam stopper housing and gasket making sure the stopper and spring are correctly positionedTighten to specifications
20Place the gasket and right-side cover into position making sure the release roller guide remains correctly positioned and
that the water pump drive adapter aligns; then install the fifteen cap screwsNote the proper location of the long cap screw