2007 Arctic Cat ATVs factory service and repair manual, Page 280Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 280

15Insert the pin into the starter gear assembly boss in the crankcase; then install starter idler gear #l 19Install the two
Housing EHiILow Shifter Assembly FRecoil Starter i NOTE: Steps 1-19 in the preceding sub-section must precede this procedure
20Place the gasket and left-side cover into position on the crankcase1NOTE: It may be necessary to push or pull the splined
HiILow range shift shaft to establish covercrankcase mating 18Place the rotorlflywheel into position on the crankshaft; then
install the nut on the crankshaft and tighten until the rotorlflywheel is properly seatedTighten to specifications 21Install