2007 Arctic Cat ATVs factory service and repair manual, Page 281Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 281

22Place the starter cup into position on the crankshaft making sure new, lubricated O-ring is inside the cupTighten the flange
way onto the shaft1 NOTE: Position the shift lever part way onto the splines and verify the subtransmission is in hi rangeIf
not, shift into hi range 24Place the shift stop housing assembly into position beneath the shift shaft housing making sure
the spring and stopper are correctly positionedTighten to specifications27Pull up on the hillow shift T-handle and guide
the T-handle stop pin into the hi range lever stop plate slot; then slide the shift lever assembly the rest of the wa onto