2007 Arctic Cat ATVs factory service and repair manual, Page 282Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 282

AInstall ring expander (4) in the bottom groove of the piston; then install the thin oil rings (3) over the expander making
C, Install the compression rings (1 and 2) so the letter on the top surface of each ring faces the dome of the pistonRotate
the rings until the ring end ga are on directly opposite sides of the piston see illustration) 1Cylinder 1 NOTE: The chrome
(silver) ring should be installed in the top position Stud Bolt Nut Cylinder Gasket Pin 6Water Hose Union 7Cap Screw 80-Ring
A CAUTION Incorrect installation of the piston rings will result in engine damage 1Install the piston on the connecting rod
making sure there is circlip on each side and the open end of the circlip faces upwards1 NOTE: The piston should be installed