2007 Arctic Cat ATVs factory service and repair manual, Page 285Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 285

14Seat the cam sprocket onto the camshaft making sure the alignment pin in the camshaft aligns with the smallest hole in
parallel to the valve cover mating surface DRecessed side of the sprocket directed toward the cam lobes ECamshaft alignment
pin and sprocket alignment hole (smallest) are aligned If any of the above factors are not as stated, go back to step 11
and carefully proceed 1 NOTE: Note the position of the alignment marks on the end of the camshaftThey must be parallel with
the valve cover mating surfaceIf rotating the camshaft is necessary for alignment, do not allow the chain and sprocket to
rotate and be sure the cam lobes end up in the down position 15Place the tab-washer onto the sprocket making sure it covers