2007 Arctic Cat ATVs factory service and repair manual, Page 299Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 299

Tensioner Plug 9Remove the coolant bypass hose from the cylinder head fitting; then remove the coolant crossover hose il
flat-blade screwdriver, hold the cam chain idler shaft shim against the shoulder of the cam chain idler shaft and remove
the shaftAccount for copper seal washer and the cam chain idler shim A CAUTION Do not rotate the engine with the cam chain
loose or severe engine damage could occur Remove the cylinder head cap screws (four mm and five 12 mm) noting the location
of the longer and shorter mm cap screws; then remove the cylinder headAccount for two alignment pins and one head gasket3-262