2007 Arctic Cat ATVs factory service and repair manual, Page 301Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 301

1 NOTE: The piston pin is full-floating type and should slide out by handIf the piston pin is stuck, use Piston Pin Puller
be replaced with new rings, note the location of each ring for proper installationWhen replacing with new rings, replace
as complete set onlyIf the piston rings must be removed, remove them in this sequence Removing Left-Side Components ARecoil
Starter BWater Pump CCover DRotorFlywheel EOil Pump AStarting with the top ring, slide one end of the ring out of the ring-groove
1Remove the four cap screws securing the recoil starter assembly to the left-side cover; then remove the recoil starterAccount
for the gasket BRemove each ring by working it toward the dome of the piston while rotating it out of the groove B AT THIS
POINT To service the recoil starter, see Servicing Left-Side Components sub-section B AT THIS POINT To service piston, see
Servicing Top-Side Components sub-sectionB AT THIS POINT To service center crankcase components only, proceed to Removing