2007 Arctic Cat ATVs factory service and repair manual, Page 304Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 304

Make sure the crankshaft protector is fully installed on the crankshaft and the rotorlflywheel puller is turned all the way
cam chain tensioner and cam chainAccount for washer 1NOTE: The oil pump is not serviceable componentDo not disassemble the
oil pumpIt is available only as complete assembly 14Remove the cap screws from the crankshaft balancers; then remove the
crankshaft balancer driven gearsAccount for two washers and two keys 12Remove the snap ring (1) from the oil pum shaft; then
remove the oil pump driven gear (2) and drive chain (3)Account for the oil pump drive pin (4) and washer (5)Page: 304 Arctic