2007 Arctic Cat ATVs factory service and repair manual, Page 305Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 305

Right-Side Components 1 NOTE: For efficiency, it is preferable to remove and disassemble only those components which need
disassembly of components may be necessaryNote the AT THIS POINT information in each sub-section 1 NOTE: The engineltransmission
does not have to be removed from the frame for this procedure Removing Right-Side Components AV-Belt Cover BDriven Pulley
CClutch Cover 1Remove the cap screws securing the V-belt cover; then using rubber mallet, ently ta on the cover tabs to loosen
the coverccount or gasket 2Remove the bearing cap; then using Spanner Wrench (pln 0444-153) to hold the drive pulley, remove