2007 Arctic Cat ATVs factory service and repair manual, Page 313Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 313

Servicing ValvesNalve GuidesNalve Seats If valves, valve guides, or valve seats require servicing or replacement, Arctic
edge of the valve faceZero the indicator 2Insert each valve into its original valve location3Install the valve springs with
the painted end of the spring facing away from the cylinder head1NOTE: If the paint is not visible, install the ends of the
springs with the closest wound coils toward the head- 3Push the valve from side to side; then from top to bottom 4Maximum
"wobble" deflection must not exceed specificationsMeasuring Valve Guide (Inside Diameter) Towards 1Insert snap gauge 112
way down into each valve guide bore; then remove the gauge and measure it with micrometer2Acceptable inside diameter range
must be within specifications3If valve guide is out of tolerance, it must be replaced3-276 Page: 313 Arctic Cat ATV 2007
-All Models 4Place spring retainer over the valve springs; then using the valve spring compressor, compress the valve springs